No power to the 4×4 switch

Tiny
PMYERS1521
  • MEMBER
  • 2003 FORD RANGER
  • 4.0L
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 281,000 MILES
I have no power to my 4×4 switch. All of my fuses are good under the hood and in the cab. Replaced the transfer case control shift module and replaced the transfer motor under the truck. Where does the power supply come from for the switch? Should I try to replace the switch?
Friday, November 25th, 2016 AT 9:47 PM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Power for the switch comes from the control module which is in the right kick panel. The ground is there as well so check to make sure the ground is good and connector is in good. Then if still no power have it scanned for codes by a mechanic. It will need programming to your truck if bad. The power wire is the white/light blue wire to switch.
Was this
answer
helpful?
Yes
No
+2
Saturday, November 26th, 2016 AT 9:36 AM

Please login or register to post a reply.

Related Transfer Case Replace/Remove Content

VIEW MORE