Heater Core is leaking

Tiny
LEO72
  • MEMBER
  • 1995 CHEVROLET SILVERADO
  • V8
  • 2WD
  • AUTOMATIC
  • 150,000 MILES
What steps do I need to follow in order to replace the heater core
Do you
have the same problem?
Yes
No
Tuesday, January 25th, 2011 AT 10:55 PM

1 Reply

Tiny
RASMATAZ
  • MEMBER
Remove or Disconnect

Engine coolant.
Instrument panel storage compartment.
Electrical connectors, as necessary.
Center floor air distribution duct.
Hinge pillar trim panels.
Blower motor cover.
Blower motor.
Steering column.
Roll instrument panel back.
Coolant recovery reservoir.
Heater hoses. Refer to "Heater Hoses" in this section.
Screw on interior side of cowl, near the evaporator pipe (if equipped) while holding heater case to the cowl.
Four screws on the engine side of the cowl holding the heater case to the cowl.
Two nuts on the engine side of the cowl holding the heater case to the cowl.
Heater case.
It may be necessary to have an assistant when removing heater case.
Heater cover.
Remove seven screws that hold cover to the heater case.

Heater core from retainer.
Was this
answer
helpful?
Yes
No
Tuesday, January 25th, 2011 AT 11:04 PM

Please login or register to post a reply.

Sponsored links