SPONSORED LINKS

2003 Mitsubishi Eclipse vehicle wont Move

Tiny
WAR EAGLE1
  • MEMBER
  • 2003 MITSUBISHI ECLIPSE
  • 80,000 MILES
Just replaced my clutch, pressure plate and throw out bearing. Vehicle ran well on test drive drove it again accelerated a little faster heard a pop and clicking sound vehicle wont move. Jacked it up put it on jack stands it goes into all gears tires turn can stop tire rotation with my foot is it the clutch adjustment or tranny gone bad
SPONSORED LINKS
Wednesday, October 23rd, 2013 AT 10:32 PM

2 Replies

Tiny
WRENCHTECH
  • MECHANIC
  • 20,757 POSTS
Check to see if one of the axles was not locked in all the way and popped out of the trans.
Was this
answer
helpful?
Yes
No
Thursday, October 24th, 2013 AT 2:20 AM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,938 POSTS
Put transmission in 1st gear and try cranking, will the car move on the starter?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, October 24th, 2013 AT 2:22 AM

Please login or register to post a reply.

Related Transmission Clutch Throw Out Bearing Replace/Remove Content

Throw out Bearing Replacement
GUIDE
Throw out Bearing Replacement
A throw out bearing is used to apply force against the clutch pressure plate to release the clutch and should be replaced as part of the normal clutch job. It is a good idea...
VIEW MORE

Sponsored links