HOW DO YOU CHANGE ALTERNATOR? PULL MOTOR? ITS A ...

  • Tiny
  • Anonymous
  • 2002 Ford Escape
  • 15,000 miles

How do you change alternator? Pull motor? Its a V6

Wednesday, December 5th, 2012 AT 11:04 PM

1 Reply

  • Tiny
  • rasmataz
  • Member

-Removal & Installation (3.0L Duratec)

Disconnect negative battery cable. Remove right side front drive halfshaft and intermediate shaft. See AXLE SHAFTS article in DRIVE AXLES. Remove right side lower splash shield screws and pin-type retainer. Remove 5 bolts and right front lower splash shield. Rotate accessory drive belt tensioner clockwise. Remove accessory drive belt from generator pulley. Disconnect generator harness connector. Remove upper and lower mounting bolts and generator from vehicle. Remove generator mounting bracket. Remove generator electrical connectors. To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS.

Was this
answer
helpful?
Yes
No
Wednesday, December 5th, 2012 AT 11:09 PM

Please login or register to post a reply.

Similar Questions