MITSUBISHI

Would This Problem Be Caused By The Maf Sensor? It Idles Perfectly To 2,000 Rpms But When You Go Beyond Its Backing From The Intake And Will...

I Am Needing Instructions And Tips, On Input Shaft Seal Replacement.

Hello 2carpros, I Went To Start My Car This Morning And I Only Get A Grinding Noise, No Cranking And No Starting. Seems To Be Starter...

Looking For A Factory Service Manual For The Car Listed Above?

So Far, I've Checked The Following, Timing Belt Is Good. Compression Is 210 Psi Across The Board. Replaced The Cam Shaft Position...

Engine Listed Above Is A - 3.5l Not 1.8. Drivers' Seat Chair Will Not Move Forward Or Back. The Lumber Support Works As It Tilts And...

I Know The Intake Rocker Arm Shaft Bolts Are 23ft-lbs. I Just Need The Torque Specification For The Exhaust Rocker Arm Shaft Side. Please...

After Swapping Out The Engine I Have A Code For The Transmission Speed Sensor And The Car Will Not Stay Running. It Drove Great For The...

I Have The Car Listed Above Gs, That Someone Cut The Wiring Harness Behind The Stereo The Stereo. Clip Is Still Intact As Are The Climate...

I Need To Know The Correct Torque For The Valve Cover I'm Replacing.