CYLINDER HEAD

I Have The Car Listed Above With A 3.5 Se It’s A C 6 Obviously. I Am Down To The Head, And I Have Cleaned Everything Up And I Have The...

I Am Working On Replacing The Vacuum Pump On My Truck. While I Have Successfully Removed The Lower Two Bolts, The Third (upper) Bolt's...

Does Removing The Cylinder Head Require Any Special Tools?

Hey Brother Back Again! Got To Quit Meeting Like This! Okay, I've Got New Cats Just Changed The Fluid And Filter On The Transmission...

I Rarely Use The Car Listed Above Vehicle (4 Door), So I Leave It Parked For Several Days At A Time Before Attempting To. I Live In San...

My Vehicle Is A Honda Rd1 Cr-v Japan Model Year 2001. I Have Been Told That The Engine Needs To Be Replaced As The Second Gasket That Was...

Please Tell Me The Best Way To Get Out The Head Bolt After I Rounded It Off.

I Have Tty Bolts (the Same Ones From Your 5.3 Video) And On My Final Pass For Bolt #9 And #10, I Accidentally Went To 90 Degrees Instead Of...

I Recently Did A Top-end Overhaul On A Nissan Yd25 Engine, Tested The Vehicle For 190 Km. Then Later Heard A Blowing Sound From The Inlet...

Can You Please Provide The Torque Spec And Sequence For The Valve Cover Gasket On The V6 3.3l Engine. If You Have A Full Guide On The...