CAMSHAFT

How Do You Time A 2.3l Oldsmobile Engine With Dual Cams?

I'm Changing Leaky Cam Cover Gaskets To Correct A Misfire On A 2.4l Quad 4. The Factory Manual Warns That The Cam Carrier Gaskets Must Be...

Engine Needs Cranking About Ten To Twenty Times To Start. Sometimes When It Starts After Five Or Six Time Cranking It Shuts Off After Three...

I Live In France And Have A Volvo Wentworth Estate 1993 Model That Has Served Me Very Well For Many Years But Unfortunately Developed A...

Need To Know Where Its Located On Engine So I Can Replace, I Have One Ordered?

Steering Problem 1989 Ford F250 V8 Four Wheel Drive Automatic Can You Tell Me How To Replace The Actuator Rod For The Ignition On A...

I Was Wondering About How Long It Would Take Someone With Good Experience But No Knowledge Of This Model To Replace The Camshaft Position...

Did A Top End Rebuild On A V6 Catera, Engine Is Not Starting. In Following The Insturctions For The Cam Gears 1, 2, 3, 4. Noticed That The...

I Have Replaced The Cam Sensor And My Car Is Still Doing The Jerking At 2500 Rpm. I Have Replace The Timing Belt Water Pump. A New Head...

I Have A 1999 Mountaineer With 100k On It. There Should Be A 5 Volt Ref At Thte Gray/red Wire At The Cmp Sensor Which Comes Out Of Pin 85...