TRANSMISSION

I Am Replacing My Slave Cylinder And Figured I Check To See If I Needed To Replace The Fourth Gear Since I Haven’t Been To Get Into Fourth...

I Can Shift The Stick Into Every Gear Position But It Just Stays In 3rd Gear, What Is The Best Way To Corect This Problem?

I Need To Know Where The Tcm Is Located On My Vehicle Listed Above. A Diagram Would Be Most Helpful Too If Possible.

I Have Low Transmission Fluid I Think How Do I Check It, It Is An Automatic

My Problems Started With A Leaky Slave Cylinder, Which I Had Repaired, Since It Was An Internal Slave The Mechanic Suggested Doing The...

So, I Replaced My Hydraulic Slave Clutch Master Cylinder And Reservoir As Well As The Clutch. First Attempt- After Bleeding Multiple...

I Hit A Rod Sticking Out Of Pavement. The Car Started To Tremble And Made Loud Noises Then I Smelled Burning And A Little Smoke. Pulled Over...

I Was Leaving To Go To Work This Morning And Out Of Nowhere Went To Put My Truck In Reverse And Nothing, I Had To Put In Park And Reverse 3...

Ignition Has Been Replaced, Problem Still Exist.

Vehicle Starts And Idles Fine But When Put In Gear It Jerks And Shuts Off. Did It Once Before And Engaging 4wd Got It Moving, Then Fine...