1998 Honda Accord starting

Tiny
MIKEDURHAM25
  • MEMBER
  • 1998 HONDA ACCORD
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 17,500 MILES
I have a accord 98 model the thing just will not stay running , on hot cold anytime u start it and it cuts right off like after second sometime it will run fine but u get u get in that car it will shut off before u get out the driveway, I lokk and read about everythong wrong with these year The problem is so common that it's been coined the "petrol station fuel relay" from fuel station attendants. The technical name for the main relay is PGM-EFI Main Relay Assembly. PGM stands for programmed, EFI stands for Electronic Fuel Injection. Could that casuse this problem the code I got with my actron is p0108 Manifold Absolute Pressure/Barometric Pressure Circuit Intermittent what is that is this the relay just to the sdie of hood latch how do I test it find it and replace it ? Dose this sound like what would make it run the shut off?
Thursday, September 4th, 2008 AT 11:34 PM

5 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Hi mikedurham25,

What you are experiencing is not due to the main relay.

You have a fault with the MAP sensor located on top of the throttle body. This will cause frequent stalling and you need to replace it to rectify the problem.
Was this
answer
helpful?
Yes
No
Saturday, September 6th, 2008 AT 12:06 PM
Tiny
MIKEDURHAM25
  • MEMBER
  • 5 POSTS
Is it black why would the map make it stall or cut gas?
Was this
answer
helpful?
Yes
No
Sunday, September 7th, 2008 AT 9:56 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Hi mikedurham25,

DTC P0108: MAP SENSOR CIRCUIT HIGH VOLTAGE.

MAP is one of the main item for monitoring/controlling idling speed and fuel supplr. If it is faulty, the engine tends to stall and starting is harder than normal.
Was this
answer
helpful?
Yes
No
Monday, September 8th, 2008 AT 8:29 AM
Tiny
MIKEDURHAM25
  • MEMBER
  • 5 POSTS
This car has a aftermarket air intake like silver tube with k&n filter connect to the throttle body, could not haveing the stock air induction cause oil or grease or what ever to clog or dirty map sensor making it fail early as it flows?

Is the map sensor the black thing on top of throttle body
dose it madder where I get this map sensor from auto zone ect?
Was this
answer
helpful?
Yes
No
Monday, September 8th, 2008 AT 9:35 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Hi mikedurham25,

Yes, the MAP is the piece atop the throttle body.

Make sure the ratings are the same, if not you might get an error code after replacement.

It is possible for the MAP to fail due to contaminations but there is no way of cleaning it.
Was this
answer
helpful?
Yes
No
Tuesday, September 9th, 2008 AT 7:42 AM

Please login or register to post a reply.

Related Engine Stall While Driving Content

Code Read Retrieval/Clear Honda
VIDEO
Code Read Retrieval/Clear Honda
Instructional repair video
Engine Stalls While Driving
GUIDE
Engine Stalls While Driving
An engine that stalls while driving and then starts back up again, either immediately or after a short time is different from an engine that just wont start or if the...
VIEW MORE