2004 Chevy Malibu Turn Signal

Tiny
SUPERDAYO
  • MEMBER
  • 2004 CHEVROLET MALIBU
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 80,000 MILES
My turn signal(right front and back) isn't working. Turn signal(left front and back) are working. I tried to change the bulb(even tried to put the working bulb on the left side to the right) but still not working. The dashboard lights is good. When I hit the hazard switch, still the right front and back turn signal isn't working and again still left part is working. Emergency lights works on both sides. Can't figure it out.
Do you
have the same problem?
Yes
No
Tuesday, June 23rd, 2009 AT 5:44 AM

1 Reply

Tiny
JDL
  • EXPERT
Hello, the turn switch grounds the circuit for right and left turns. Dark green wire with white tracer shows to be the ground circuit for right turn. You can use a jumper as a test ground for the right turn signal, if the signal then works, the problem is in the wiring from the test point to the turn switch or the switch it self.

You might check for manufacturer specific codes, see if that shows anything.
Was this
answer
helpful?
Yes
No
Tuesday, June 23rd, 2009 AT 10:04 AM

Please login or register to post a reply.

Recommended Guides