Holden Commodore VP 92 V6 (Australia)

Tiny
CONROMIA
  • MEMBER
  • 1992 ALL OTHER MAKES ALL OTHER MODELS
I have a Holden Commodore VP 92 V6, and it wont start after a short or long run. I have replaced the engine and fuel pump and fuel filter. The fuel pump is inside the tank. Sometimes the fuel pump gurgles. What can it be causing it to not start within 5mins after run?
Tuesday, November 13th, 2007 AT 6:25 PM

3 Replies

Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
Hi there,

You best get a code read on the ECU, but most often with these VP's is a faulty crank angle sensor, followed by an ignition module, both should give a code. Start there.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Wednesday, November 14th, 2007 AT 5:21 AM
Tiny
CONROMIA
  • MEMBER
  • 2 POSTS
Mate thank you replaced the sensor and everything works like a charm. : )
Was this
answer
helpful?
Yes
No
Wednesday, November 14th, 2007 AT 10:06 PM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
G'day there,

Good to hear of the result, keep us in mind next time and don't forget to vote, it all helps keep us doing what we do best.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Wednesday, November 14th, 2007 AT 10:55 PM

Please login or register to post a reply.

Related Fuel System Fuel Pump Replace/Remove Content

Fuel Pump Replacement
GUIDE
Fuel Pump Replacement
When a fuel pump goes out it can do so one of two ways either it can quit and stop working or it can fail intermittently causing the engine to stall or not start.
VIEW MORE