2007 Chevrolet Cobalt Exedy OEM Replacement clutch kit

Tiny
HELLBILLY658
  • MEMBER
  • 2007 CHEVROLET COBALT
  • 2.0L
  • 4 CYL
  • TURBO
  • FWD
  • MANUAL
  • 140,000 MILES
I am getting ready to replace the clutch in my car. I purchased the Exedy OEM Replacement clutch kit and nowhere on any site does the specifications say it does/doesn't bolt directly to the factory flywheel.
Do you
have the same problem?
Yes
No
Thursday, January 2nd, 2014 AT 8:55 PM

5 Replies

Tiny
SATURNTECH9
  • MEMBER
So you have the cobalt ss?Why wouldn't the pressure plate bolt to the flywheel?
Was this
answer
helpful?
Yes
No
Thursday, January 2nd, 2014 AT 9:04 PM
Tiny
HELLBILLY658
  • MEMBER
I don't know why it wouldn't. I am concerned about it because there is no mention of it on any site to include Exedy. It is a much more labor intensive repair than clutches I have replaced in the past. I'm trying to find out if it will fit before we start taking everything apart and find out the hard way.
Was this
answer
helpful?
Yes
No
Thursday, January 2nd, 2014 AT 9:20 PM
Tiny
SATURNTECH9
  • MEMBER
If its a stock clutch that pressure plate should bolt right up to the stock flywheel I dont see why it shouldn't. Whats the part number of your clutch kit?
Was this
answer
helpful?
Yes
No
Thursday, January 2nd, 2014 AT 10:04 PM
Tiny
HELLBILLY658
  • MEMBER
Exedy GMK1016
Was this
answer
helpful?
Yes
No
Thursday, January 2nd, 2014 AT 10:20 PM
Tiny
SATURNTECH9
  • MEMBER
Thats the part number I see for your car I have ran across part numbers that were wrong in the application but that's not that common.
Was this
answer
helpful?
Yes
No
Thursday, January 2nd, 2014 AT 10:31 PM

Please login or register to post a reply.

Recommended Guides