REDUCED POWER

2004 Isuzu Rodeo

Tiny

maukatallguy

May, 25, 2011 AT 8:30 PM

2004 Isuzu Rodeo 3.5L sets codes P1239, P1249 & P1767 these turn out to be 'manufacturer codes' can you help interput them? Vehicle also has a P0125 code 'Insufficient Coolant Temp For Closed Loop Fuel Control', where is that sensor? The vehicle starts and runs but very low power. There is a 'Reduced Power' warning on the dashboard.
Tnx for your assistance.

FOUND 14749 RELATED QUESTIONS

4 Answers

Tiny

rasmataz

May, 28, 2011 AT 3:15 AM

Could be caused by one of the following below

Oxygen sensor.
Catalytic converter.
Fuel injectors dirty/sticking.
Mass airflow sensor/Airflow meter.
Throttle position sensor.
Crankshaft position sensor
Knock sensor
Manifold absolute pressure sensor.
EGR Valve
Fuel pressure regulator leaking or defective fuel pump.
Fuel contamination.
Foul/defective spark plugs.
Open spark plug wires.
Ignition coil/Coil packs defective.
Incorrect ignition timing.
Cap and rotor.

Note: If it doesn't apply disregard it and keep testing.

Tiny

maukatallguy

May, 28, 2011 AT 4:07 AM

Rotfflmfao : )

Tiny

rasmataz

May, 28, 2011 AT 8:07 AM

Dunno your lingo here but if you need help best response properly otherwise go somewhere else and play or I'll 86 you from here-

Tiny

maukatallguy

May, 28, 2011 AT 5:17 PM

Well rasmataz, That response just struck me as funny, doesn't address the codes I was able to read, but the mfgr seems to hold closer, nor the location of the sensor that the one code that does have some info about it available. It did however list every possible engine performance fault, most of which would throw a trouble code if they were a factor. Sorry that we can't laugh while we look for solutions.

Please login or register to post a reply.

Catalytic Converter Replacement Volkswagen
Find Out How to Test Your Catalytic Converter
Fuel Filter Replacement Ford F-250
Fuel Filter Replacement Toyota Tacoma