1996 rodeo ob2 wont scan

1996 ISUZU RODEO
168,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
INLINE1809
  • MEMBER
  • 2 POSTS
my engine light is coming on but scan port is not getting power to scan it. it started to missfire bad and not go over 15 mph. engine light has started to flash.
May 4, 2011 at 4:24 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
Test all the fuses. One of them powers the connector. Most cars use the lighter fuse.
May 4, 2011 at 4:38 PM
Avatar
INLINE1809
  • MEMBER
  • 2 POSTS
all fuses are good
May 4, 2011 at 7:09 PM
Advertisement
Avatar
WRENCHTECH
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 20,761 POSTS
Use a test light and check pin #16 for power.
Image (Click to enlarge)
Attached Media
May 4, 2011 at 7:37 PM