What do I have to take out to get to the air.

Tiny
SHINIESTAR
  • 2000 GMC SAVANA

What do I have to take out to get to the air door actuator? And its exact location would be from going under dash from the inside of van right?

Do you
have the same problem?
Yes
No
Monday, December 24th, 2012 AT 5:06 PM

1 Reply

Tiny
ASEMASTER6371
  • EXPERT
  • 25,554 POSTS

Remove the engine cover.
Remove the center floor air outlet.
Disconnect the vacuum connector.
Remove the valve, inner mode door (1), outside air recirculation door (3), outer mode door (4), by unsnapping the valve from the heater case.
Disconnect the linkage from the valve.
INSTALLATION PROCEDURE

Connect the linkage to the valve, inner mode door (1), outside air recirculation door (3) and outer mode door (4).
Install the valve by snapping the valve to the heater case.
Connect the vacuum connector.
Install the center floor air outlet.
Install the engine cover.

Was this
answer
helpful?
Yes
No
-1
Monday, December 24th, 2012 AT 11:37 PM

Please login or register to post a reply.

Other Blend Door Actuator Location Questions