1995 Ford Ranger Temp gauge pegs out

1995 FORD RANGER
185,000 MILES • 3.0L • V6 • 2WD • MANUAL
Avatar
RICK JONES
  • MEMBER
  • 3 POSTS
Ok like i did the usual things, I e. thermostat, water pump, , fan clutch, radiator, both sensors, replaced the instrument panel,. Checked the temp. on hoses radiator, and the sending unit area , With the gauge pegged, the reading was 185, So whats next? Thanks. i mean short of putting in a Manuel temp gauge that is , Thanks Rick
Aug 12, 2015 at 6:38 PM
Advertisement
Avatar
CARADIODOC
  • CERTIFIED EXPERT
  • 34,308 POSTS
There's only one sensor for a dash gauge. It has a single-wire connector. Two-wire sensors are for the Engine Computer. Unplug the gauge sensor. The gauge should go to full "cold". If it does not, that wire is grounded somewhere.
Aug 12, 2015 at 10:48 PM
Avatar
RICK JONES
  • MEMBER
  • 3 POSTS
Thanks for the reply, and yes i do know the temp gauge has one wire, just wanted to find out if there was a bi metal sensor inline to the gauge. With newer ie. 90 models and up you never know . .. Thanks again Rick
Aug 13, 2015 at 5:40 AM
Advertisement