FORD COMPUTER

I Have Tried The Jumper Method And I Have Tried A Scanner (from Autozone); I Have Also Tried Connecting The Single Connector To A Ground....

Where Do You Connect A Code Reader? I Just Had A Full Tune Up On My Ranger A Few Weeks Ago. The Gas Gauge Isn't Working So I'm...

When I First Got The Truck The Front Passenger Side Had Major Collision Damage. After Doing The Necessary Body Work The Truck Ran Fine....

Where Is The Pcm?

The Car Listed Above Is A Gt, Gen Ii Coyote Engine. Did An Engine Swap. Everything Lined Up Perfectly, Nailed The Timing But Cranked It...

When You Take Off In Drive Just Before It Shifts It Goes Into Fail Safe Mode, We Pulled The Motor And Had It Rebuilt By A Machine Shop It...

The Check Engine Came On Because I Needed To Clean The Throttle Body, Which I Did Now I Need To Reset The Check Engine Light

Sometime Doesn't Start First Time, But Has Started Eventually. Sometime Engine Quit's While Driving, Does Start When It Want's...

No Scanner Connection, It Stays Off. I Check The Scanner On Other Vehicle And It Is Okay.

I Have An Active Code P0354. I Need To Check The Wiring For Either An Open Or Short. The Pcm I Have Has Three Separate Plugs Not The Large...