IGNITION

I Pulled The Codes Off The Obd Port And Got Codes For Crank Sensor And Also Cam Sensor. I Did A Ohm Test On Bolth The Cam And Crank Sensor...

I Recently Bought A 92 B2600i. The Guy I Bought It From Said The Ecm Was Bad, Sent It To Florida, Checked Out Fine. I Have Power To The Coil...

For The 5th Time Today, I Have Replaced Plug Wires, Plugs, Cap, Rotor, And Fuel Filter. It Cranks Over But Will Not Start.

The Inside Of The Disttributor Is Good

Six Cylinder Front Wheel Drive Automatic 110,000 Miles. I Took Off The Three Back Wires And Had To Leave I Do Not Remember The Order...

93 302, (stroked 347), B-cam, Gt40 P Upper From Heads Up, Custom Cold Air, Shorty Headman Headers, B Cam Is Hydraulic Roller With...

To Install The Rear Hub Nut Do I Install As One Assembly Or Do I Install Each Nut One At A Time, What Is The Torque Spec. The Hub Nut...

This Question Is About A 1984 Honda Crx 1.3 5 Speed. I Changed The Head Gasket And Rebuilt The Carb. When I Try Start It, It Just Turns(...

Is The Timing Set At 1 O'clock With Number One Piston At Tdc? Or 4 O'clock With Number One Piston At Tdc? Thank You, Jc

I Own A 1998 Rodeo Isuzu 3.2 L And Like To Know What The Sparkplug Gap Should Be. Also Want To Know About My Engine Check Light It Comes On...