2006 Honda Civic Where is the starter

Tiny
OLDLEGGER
  • 2006 HONDA CIVIC

Engine Mechanical problem
2006 Honda Civic 4 cyl Two Wheel Drive Automatic 68000 miles

Where is the starter located on the engine? Is it hard to remove and replace?

Do you
have the same problem?
Yes
No
Saturday, October 3rd, 2009 AT 7:11 AM

1 Reply

Tiny
KHLOW2008
  • EXPERT
  • 41,975 POSTS

Hi oldlegger,

Starter is located at rear of engine below the intake manifold.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterLocation06CivicFig152_1.jpg



Here are removal procedures.

STARTER REMOVAL AND INSTALLATION
REMOVAL
1 . Make sure you have the anti -theft code for the audio system and the navigation system (if
equipped), then write down the audio presets.

2 . Disconnect the negative cable from the battery first, then disconnect the positive cable.

3 . Remove exhaust pipe A.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig15_1.jpg



4 . Remove the intake manifold bracket.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig16_1.jpg



5 . Remove the harness clamps (A) and harness connector (B) from each clamp.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig17_1.jpg



6 . Remove the two bolts securing the starter, then remove the starter from the engine.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig18_1.jpg



7 . Disconnect the starter cable (A) from the B terminal. Disconnect the connector (B) from the
S terminal, then remove the starter.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig19_1.jpg



INSTALLATION
1 . Install the starter cable (A) and connector (B). Make sure the starter cable crimped side of the ring terminal faces away from the starter when you connect it.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig20_2.jpg



2 . Install the starter, then loosely install the upper mounting bolt (A) and lower mounting bolt
(B).


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig21_1.jpg



3 . Tighten the upper mounting bolt, then tighten the lower mounting bolt.

4 . Install the harness clamps (A) and harness connector (B) to each clamp.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig22_1.jpg



5 . Install the intake manifold bracket.


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig23_1.jpg



6 . Install exhaust pipe A. Use new gaskets (B) and new self -locking nuts (C).


http://www.2carpros.com/forum/automotive_pictures/192750_StarterRemoval06CivicFig24_1.jpg



7 . Connect the positive cable to the battery first, then connect the negative cable.

8 . Start the engine to make sure the starter works properly.

9 . Enter the anti -theft code for the audio system and the navigation system (if equipped), then enter the audio presets.

10 . Set the clock (on vehicles without navigation).

Was this
answer
helpful?
Yes
No
+5
Sunday, October 4th, 2009 AT 2:50 PM

Please login or register to post a reply.

Other Starter Location Questions