2000 Chevy Blazer how to bleed the brakes after replacing t


Brakes problem
2000 Chevy Blazer 6 cyl Four Wheel Drive Automatic

what is the best way to bleed the brakes after replacing the old brake pads?

Do you
have the same problem?
Wednesday, April 1st, 2009 AT 9:26 AM

1 Reply

  • 16,976 POSTS

Bleeding procedure is below.

Raise the vehicle in order to access the system bleed screws.
Bleed the system at the right rear wheel first.
Install a clear hose on the bleed screw.
Immerse the opposite end of the hose into a container partially filled with clean DOT 3 brake fluid.
Open the bleed screw 1 / 2 to 1 full turn.
Slowly depress the brake pedal. While the pedal is depressed to its full extent, tighten the bleed screw.
Release the brake pedal and wait 10-15 seconds for the master cylinder pistons to return to the home position.
Repeat the previous steps for the remaining wheels. The brake fluid which is present at each bleed screw should be clean and free of air.
This procedure may use more than a pint of fluid per wheel. Check the master cylinder fluid level every four to six strokes of the brake pedal in order to avoid running the system dry.
Press the brake pedal firmly and run the Scan Tool Automated Bleed Procedure. Release the brake pedal between each test.
Bleed all four wheels again using Steps 3-9. This will remove the remaining air from the brake system.
Evaluate the feel of the brake pedal before attempting to drive the vehicle.
Bleed the system as many times as necessary in order to obtain the appropriate feel of the pedal.

Thanks for using 2CarPros. Com!

Was this
Thursday, April 2nd, 2009 AT 1:20 AM

Please login or register to post a reply.

Recommended Guides