After feeling a little pop in clutch pedal car will not Move

I am going to O’reilly’s auto parts, is that the name of the seal?

All bolts were tight. The Lock ring was bent on the driver axle, so I have a replacement. I actually put it back together and dropped it back in the car already, but need to replace the axle seals. Before installing the new axles.

I’ve got two CV axle seals, and they are rubber.

I haven’t gotten them yet, I only ordered them from O’reilly’s. They will be there tomorrow, so I will take the old one out and match them up when I go to pick them up.

The lock ring on the end of the driver side axle was bent when I got it out. I had to cut the axle out, because I couldn’t get it broken loose with a 1/2 inch breaker bar, or air impact. Was a pain! Lol. So I have a new axle, and going to get new seals tomorrow, but the battery in, seals, axles, and see what that does.

Roy, I picked up the seals today, and they look too big to be the axle seals. I was unable to pull the old one out, by chance do you have a part number for them? I have looked everywhere online and can’t even find the seals themselves.

This is the one I got from O’reilly’s, so it is the incorrect one.

Roy, so I just need two of those correct? They are not different for each side?

Roy, I got it all back together and back in the car. Now I have to jerk it really hard to put it in reverse. So hard that I feel like I’m going to break the shifter, and I have to use both hands, same taking it out of reverse. I have no clue what is going on now. If I don’t jerk it really hard, and just normal, it feels like it goes in, but then when I let out of the clutch it starts to grind. I am almost ready to scrap the car.

Help! I also forgot to add that I did change the transmission fluid and it is full. The only gear I have this problem with is reverse, and it was fine before everything was pulled to check the clutch and everything else

No reverse is the only gear I am having issues with. I can’t get it to go in smoothly at all. No matter if I go from first to reverse or not. With the car on and off I have to slam it really hard.

Any ideas what issue maybe? I’m so lost and tired of pulling this engine and transmission, lol.