HOW TO PUT POWER STEERING PUMP ON

2004 Dodge Caravan

Tiny

Anonymous

November, 7, 2012 AT 1:12 PM

How to put power steering pump on

FOUND 955 RELATED QUESTIONS

1 Answer

Tiny

hmac300

November, 7, 2012 AT 1:55 PM

REMOVAL PUMP (3.3L/3.8L ENGINE)

1. Remove the ( ) negative battery cable from the battery and isolate cable.
2. Remove the wiper module (unit) (Refer to WIPER MODULE ).
3. Raise the vehicle.
4. Remove the drive belt splash shield.
5. Remove the pressure hose routing bracket bolt (Fig. 9 ).

Fig. 9: Locating Pressure Hose Routing Clamps
Courtesy of DAIMLERCHRYSLER CORP.

6. Lower the vehicle.
7. Remove cap from power steering fluid reservoir.
8. Using a siphon pump, remove as much power steering fluid as possible from the power steering fluid reservoir.
9. Disconnect the pressure hose from the pump (Fig. 10 ).

Fig. 10: Locating Supply And Pressure Hoses At Pump
Courtesy of DAIMLERCHRYSLER CORP.

10. Disconnect the fluid supply hose from the pump (Fig. 10 ).
11. Remove the three front mounting bolts through the pulley (Fig. 11 )

Fig. 11: Locating Pump Mounting
Courtesy of DAIMLERCHRYSLER CORP.

12. Remove the pump (with pulley) through the engine compartment rocking it over the aluminum bracket.

Please login or register to post a reply.

Power Steering Pump Replacement Chevy Tahoe
Steering Pump Replacement Mercedes Benz
Power Steering Fluid Flush Chevrolet Blazer
Power Steering Fluid Change Kia Sportage
Power Steering Pump Pulley Removal