2001 Ford Focus wont start

Tiny
COOKIEMNSTR
  • MEMBER
  • 2001 FORD FOCUS
  • 2.0L
  • 4 CYL
  • FWD
  • AUTOMATIC
My ford focus died suddenly while driving and wont start? Had code p0340 so replaced camshaft position sensor but car still wont start, any ideas
Do you
have the same problem?
Yes
No
Sunday, September 14th, 2014 AT 2:29 PM

1 Reply

Tiny
JACOBANDNICKOLAS
  • EXPERT
The camshaft position sensor signal code is set when a signal from the sensor is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking. If you replaced the sensor, check wiring between the sensor and ECM. Chances are there is a broken or corroded wire.

Check to see if there is spark to the plugs to confirm this is still the issue.
Was this
answer
helpful?
Yes
No
Sunday, September 14th, 2014 AT 7:43 PM

Please login or register to post a reply.

Recommended Guides