I can not get my car to start

Tiny
JIMC83
  • 2000 CHRYSLER CONCORDE
  • 180,000 MILES

With the cam sensor plugged in but it will start with it unplugged. It will run like its missing when unplugged. Checked timing. Replaced cam sensor.

Do you
have the same problem?
Yes
No
Saturday, February 25th, 2012 AT 6:31 PM

5 Replies

Tiny
HMAC300
  • EXPERT
  • 46,997 POSTS

Check your fuel pressure and have the engine scanned. It may be acam phaser problem if there is one.

Please consider a donation to help us answer more questions.
Was this
answer
helpful?
Yes
No
Saturday, February 25th, 2012 AT 6:39 PM
Tiny
RASMATAZ
  • MEMBER

Do you have a check engine light?

Did you check the CMH wiring back to the computer for short/open circuit? Check the crankshaft sensor-also refer to this link:http://www.2carpros.com/articles/engine-misfires-or-runs-rough

Was this
answer
helpful?
Yes
No
Saturday, February 25th, 2012 AT 6:43 PM
Tiny
JIMC83
  • MEMBER

The rpm gage works could the crank sencer be bad

Was this
answer
helpful?
Yes
No
Saturday, February 25th, 2012 AT 6:49 PM
Tiny
JIMC83
  • MEMBER

The only check light is the cam senser but I replaced it

Was this
answer
helpful?
Yes
No
Saturday, February 25th, 2012 AT 6:56 PM
Tiny
RASMATAZ
  • MEMBER

Check/Test both of them again-

Was this
answer
helpful?
Yes
No
Saturday, February 25th, 2012 AT 7:12 PM

Please login or register to post a reply.

Related Engine No Start Questions

Help us by donating