I just replaces the starter/solenoid last one.

Tiny
ANONYMOUS
  • MEMBER
  • 2000 CHEVROLET S-10
  • 175,000 MILES
I just replaces the starter/solenoid last one was bad and wouldnt turn on just alot of clicking now when I replaced with the new one same thing just alot of loud clocking now I have notice that my battery voltage is very low under 9 volt could this be my issue is so can I just simple fix it by getting a jump or recharging the battery?
Thursday, December 27th, 2012 AT 8:08 PM

1 Reply

Tiny
CARADIODOC
  • MECHANIC
  • 34,330 POSTS
Start by charging the battery at a slow rate for at least an hour, then measure the voltage. It must be near 12.6 volts. Measure it again with the engine running. It should be between 13.75 and 14.75 volts. Have the generator professionally load-tested to see if if is capable of producing full output of around 90 amps.
Was this
answer
helpful?
Yes
No
Friday, December 28th, 2012 AT 6:41 AM

Please login or register to post a reply.

Related Starter Solenoid Replace/Remove Content

VIEW MORE