BECOME A MEMBER
Sign up with Facebook
I AGREE TO THE
Login with Facebook
BECOME A MEMBER
2000 CHEVROLET S-10
4.3l fuel pressure. 60psi good spark at end of coil wire but no fire at plugs, installed new dist. Cap and rotor button
have the same problem?
Sunday, January 6th, 2013 AT 7:35 PM
What about the coil wire to the distributor?
Sunday, January 6th, 2013 AT 7:38 PM
Strong fire at end of coil wire, none at end of plug wires
Sunday, January 6th, 2013 AT 7:51 PM
Re check your cap and rotor. Something wrong in there
Sunday, January 6th, 2013 AT 7:56 PM
to post a reply.
Related Ignition Coil Wiring Harness Replace/Remove Questions
I Have A 96 S10 4.3. Its Goin Threw Spells Where It...
I Have A 96 S10 4.3. Its Goin Threw Spells Where It Wont Start It Has Good Fire Good Gas Plenty Of Suction All Compresion Is Good Iv...
1991 Chevrolet S-10 No Spark From Coil Wire
I Had No Spark From Coil Wire, So I Ereplaced Coil. It Ran About 2 Miles And Then Cut Out Again. Checked For Spark From New Coil, No Spark...
What Would Cause My 12v Pink Power Wire Running To My...
Hi I Have A 1996 Chevy S10 Truck With A 4.3l V6 Vortec. A Few Months Ago The Batterey, The Alternator, And The Fuel Pump Were All...
1983 Chevy S-10 Ignition Coil Burns Out In Minutes
Electrical Problem 1983 Chevy S 10 6 Cyl Two Wheel Drive Automatic 120000 Miles I Just Did A Carburetor Rebuild. I Started Up The Truck...
Ask a Car Question. It's Free!
Ignition Coil Replacement Ford Taurus
Ignition Coil System Test Repair - All Cars
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.