What is the issue? The connector is under the drivers side of the dash
August, 28, 2012 AT 6:38 AM
What model is that and where are you located? For some Asian countries there are no OBD-II connectors even up to 1999 and you need have OBD-II connector for scan tools.
August, 28, 2012 AT 9:47 AM
The car is Honda Legend model 1999 and I'm in the Arab Gulf states, where I went to the garage Auto Repair for computer programming work, but unfortunately we did not find place and link a computer if possible attach any image found this link and you very much.
August, 28, 2012 AT 9:58 AM
Check behind the glove box. It most probably is a 2 connector, 3 pin and 2 pin socket type.
2 pin is SCS short connector whereby you can get flash codes by bridging the terminals and turning ignition ON.
Scan tools needs an adapter for the 3 pin DLC socket.
Other areas you should check would be below the radio on either side of center console.
August, 28, 2012 AT 10:10 AM
I've seen some of them located on the passenger side, in front of the console and some of them get hidden behind ash trays in the center console.
August, 28, 2012 AT 6:21 PM
Well will examine the places and tell you later Thank you
August, 30, 2012 AT 11:45 AM
Sorry I could not link to any solution to my problem was examined in the places mentioned but I can not find something and I need to check a computer for the following reasons
- Srs light lit
- Abs light lit
- Hand Break lit light
August, 30, 2012 AT 12:10 PM
It should be there, behind the glove box. Did you check at the edges of carpet?
As I mntioned, don't expect an OBD-II terminal.
August, 30, 2012 AT 12:26 PM
The OBD2 connector should be right under the left side of the dash.