Ball joint /tie rod/replacement

Tiny
MAZHYPER1
  • MEMBER
  • 1996 FORD RANGER
  • 4 CYL
  • 4WD
  • MANUAL
  • 136,000 MILES
Balljoint replacement
Sunday, November 21st, 2010 AT 4:59 PM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
You don't have a ball joint on your front end. You do have tie rods. If you replace that then you need to count how many times you turn the hoint intoit'sconnector. Then you need to get the front end aligned.
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
Sunday, November 21st, 2010 AT 5:21 PM

Please login or register to post a reply.

Related Ball Joint Replace/Remove Content

Ball Taper Joint Release
GUIDE
Ball Taper Joint Release
The car must be jacked up off the ground and supported on jack stands. You may need to remove the wheel to be able to access the ball joint more freely. There are two...
VIEW MORE