BECOME A MEMBER
It is free to join!
I AGREE TO THE
BECOME A MEMBER
CLUTCH PRESSURE PLATE WON'T TIGHTEN TO FLYWHEEL
1993 Suzuki Sidekick
May, 23, 2012 AT 4:02 PM
I replaced the clutch, but when I put the new one on, I couldn't tighten down to touch the flywheel. There is a gap in between pressure plate and flywheel, about 1/16 inch
FOUND 424 RELATED QUESTIONS
Where Is The Flywheel Cover Located?
Is My Flywheel Too Tight?
May, 23, 2012 AT 4:20 PM
It has to tighten down unless you have the wrong disc preventing it. Make sure you don't have the disc upside down.
May, 23, 2012 AT 4:21 PM
Did ya get the right parts? Is the clutch backwards?
May, 23, 2012 AT 5:25 PM
Got all the right parts and all the parts are on correctly
May, 23, 2012 AT 5:27 PM
Sure they are.
May, 23, 2012 AT 5:51 PM
Im saying parts all so.
May, 30, 2012 AT 8:00 PM
Compare/measure new parts to old.
to post a reply.
Engine mechanical problem 2003 ford mustang v8 two wheel drive manual 3500 miles do you have any tricks for the removal of engine
Starter And Fly Wheel
Electrical problem 1992 mitsubishi eclipse 4 cyl front wheel drive automatic 122456 miles hi i have recently put a new starter i
Fly Wheel Is Seized
Transmission problem 1998 ford explorer 4 cyl four wheel drive automatic 180000 miles i am putting a 99 ford explorer tranmission
Clutch/Flywheel/Rear Main Seal Replacement
Ask a Car Question. It's Free!
Need To Replace Your Clutch? See How The Pros Do It
Need To Remove Your Manual Transmission? Do It Like A Pro
Wonder Why an Engine Flywheel Works? Here Is How
Starter Motor Replacement Ford Mustang
Pulling an Auto Trans? Easy Instructions
Need A New Starter Motor? Replace It Like The Pros
© 1999 - 2015 2CarPros, Inc.