'68 Ford Falcon engine problems

Tiny
68CINCYFALCON
  • MEMBER
  • 1968 FORD FALCON
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 36,000 MILES
I have a 1968 Ford Falcon with an inline 6 200ci engine. There has been oil leaking into the number 1 cylinder spark plug on the tip which causes the engine to run really rough and stall. There is also blue smoke coming out of the exhaust upon start up and acceleration from a stop. I have researched problems that involve these symptoms and have had results such as bad valve seals and bad piston rings but, being new to fixing cars, I don't know what is the problem.
Friday, December 31st, 2010 AT 5:20 AM

3 Replies

Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
Is this an Australian XM /XP falcon?

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Friday, December 31st, 2010 AT 6:13 AM
Tiny
68CINCYFALCON
  • MEMBER
  • 2 POSTS
No it is an american falcon.
Was this
answer
helpful?
Yes
No
Friday, December 31st, 2010 AT 7:34 PM
Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
OK, blue smoke on start up is constant with oil passing the valve stem seals, but if you are also getting smoke on acceleration this can be a ring problem, this will also normally show up with smoke on over run, that is road speed and back off the throttle, do you see this as well? I would get a leak down test to check the condition of the rings, start here.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Friday, December 31st, 2010 AT 11:47 PM

Please login or register to post a reply.

Sponsored links