FORD MUSTANG COMPUTER

Found 25 results

Select a filter to limit the results

Diagnostic Connector ALDL Fuse Limp Mode - Reduced Power Location Monitor Not Resetting No Communication Program Read Codes Replace/Remove

Dropping Fuel Pressure And Goes Into Limp Mode?

The Car Is Running About 20-29 Lbs Of Fuel Pressure Under A Load It Drops And Goes Into Limp Mode. If You Stop And Restart It Resets Itself...

Asked by bullitt1939 ·

7 ANSWERS

18 IMAGES

1999

Computer

A car's computer or PCM - ECM (powertrain control module - engine control module) is designed to read various sensors such as the crankshaft position sensor to deliver...

Cannot Get OBD 1 Codes

I Have Tried The Jumper Method And I Have Tried A Scanner (from Autozone); I Have Also Tried Connecting The Single Connector To A Ground....

Asked by beahlers ·

15 ANSWERS

13 IMAGES

1995

Code P0017 And P0016, Can I Get The PCM Pin Out?

The Car Listed Above Is A Gt, Gen Ii Coyote Engine. Did An Engine Swap. Everything Lined Up Perfectly, Nailed The Timing But Cranked It...

Asked by Tabitha B Ouimet ·

1 ANSWER

14 IMAGES

2016

PCM Pinout?

Two Towers Not Firing On Coil. I Discovered There Is No Ground Signal At The Coil For Those Two Towers That Fire Cylinders Three And Four. I...

Asked by chuckhotrod ·

6 ANSWERS

11 IMAGES

2003

Crank No Start, The Anti-theft Is Engaged But We...

I Have The Car Listed Above 40th Anniversary, I Need The Wiring Diagram For The Bcm/dash Harness For The 2004 And A 2003 Gt Dash Harness....

Asked by Gailey2006 ·

6 ANSWERS

17 IMAGES

2004

Drive Cycle Incomplete

I Had Issues With The Check Engine Light Coming On Repeatedly. The Last Time I Fixed What Was Wrong I Replaced The Fuel Filter Then Reset...

Asked by Steven Hoffman ·

1 ANSWER

2 IMAGES

2000

OBD2 Monitors Showing "not Ready"

My '98 Mustang Cobra With 4.6l And 90k Miles Needs A Smog Test. It Has Failed Due To The Fact That 3 Of The Test Monitors Show "not Ready"....

Asked by pete3323 ·

12 ANSWERS

Injectors 2&8 Work But Dont Operate (PCM?)

1998 Mustang Gt - 2 Fuel Injectors (2&8) Not Getting Proper Ground From Pcm. 12vdc Shows Up At The Pigtail For All Injectors. Injectors...

Asked by ibanezsvo ·

5 ANSWERS

1998

PCM And 42 Pin Connector Pinout Diagrams Needed Please

Hello, I Need To Get Pinout Diagrams For Pcm And 42 Pin Connector Please? I Actually Have Wiring Diagrams I Can Look At For The Pcm, But...

Asked by Alex Gatlin ·

3 ANSWERS

5 IMAGES

1994

ECU Swap

Can I Take An Ecu From A 2004 Mustang And Put It In A 2000 Mustang?

Asked by Chris kinard ·

5 ANSWERS

1 IMAGE

2000

Ask a new Ford Mustang question

Sponsored links

Ask a Car Question. It's Free!

SPONSORED LINKS

Online car repair manuals

Online car repair manuals

© 1999 - 2024 2CarPros, Inc.