FORD

I Was Going 60mph For 20 Minutes. Then It Lost Power. Gauges Didn't Show Temperature Until It Stop, And I Shut It Off. It Was Very Hot...

4r75w Transmission. Rebuilt Valve Body Replaced Two Solenoids And Od Servo. Now The Truck Won't Do Anything, And New Battery Drains...

The Manual Lift Pump Went Out I Replaced It And Now The Truck Won't Start Unless I Spray It With Starting Fluid Then Shuts Off A Second...

Had Radiator Changed Because Of Leek Now Fans Won't Come On To Cool Engine Fans Will Stay On If I Leave Ac On Or If I Unplug The Coolant...

Can You Provide Some Instructions? Also, Do I Need To Bleed The Slave Cylinder Before Installing It, If So, How?

Wanting To Make Sure Phasers Are Orientated Correctly On Cams Before Orientating Timing Marks To Finish Primary Chain Timing.

Purchased This Truck Yesterday. The Previous Owner Told Me The Engine Was Rebuilt About 6-8 Months Ago. Drove The Truck Home With It Running...

Went To Clean The Iac And Discover There Is No Wiring Harness Pigtail, And I Can't Find Where To Hardware The New Pigtail. Please Help...

No Heat On Driver Side, And Only Blows Air From The Face Vents On Both Sides. Will Not Switch To Defrost Or Floor Vents. Running The Self...

If You Choose Front Very Little Air Comes Out From There.