FORD ENGINE

So I Recently Had Work Done On My Car, Replacing The Ac Compressor, The Serpentine Belt, And The Tensioner Assembly, And Last Night I...

I Bought A Tool To Help In Moving The Tension Pulley But Dont Know How To Use It It Doesnt Seem To Move The Pully At All No Matter How Much...

Okay, So I Bought The Truck Listed Above With A 5.4 Triton. It Had Been Sitting For A While, So The Truck Used To I Get Up 45-60 Mph On...

Basically, I Just Need The Vacuum Diagrams For This Truck Preferably For Each Of The Systems Using Vacuum. 8-98a-r02. Thank You

The Truck Runs Well And Clean, Has Aftermarket Wide Wheels. When You Drive There Is A Vibration/noise From Under The Seat, Not Familiar...

I Replaced The Intake Manifold Gaskets On The Car Listed Above Gt Model, And Now It Doesn't Want To Start. I Did Not Torque The Intake...

They Say It Has An Issue But The Engine Sounds Normal.

Car Starts In One Shot, Stays On As Long As I Like. If I Shut It Off, It Will Not Start Again

Been My Daily Driver For Four Years Now, Runs Good And Is Reliable. However, Today It Stalled Out While Going Down The Road And Wouldn'...

Installed A New Battery And Starter And The Car Still Won't Crank. Not Sure Each Fuse And Relay I Need To Check. The Fuses I Have...