FORD ENGINE

I Have A 98 Ford Explorer, I Just Had A New Tansmission Installed, New Upper And Lower Ball Joints And Control Arms, Full Tune Up, New...

When I Try To Squeeze The Pistons In, The Other One Wants To Come Out. They Don't Both Go In Together. I Can Still Get The Caliper To...

My Car Was Having Classic Signs Of Bad Iac Valve Such Has Revving To 2500-3000 Rpm, Stalling On Occasion And The Diagnostic Code Reader...

Other Category Problem 2002 Ford Mustang 6 Cyl Wheel Drive Type Unknown Manual 145000 Miles I Have A 00 Mustang V6 3.8 Standard Shift...

I Can't Get The Oil Filter Off To Change The Oil In My Ranger. Is There Some Trick Or Did The Last Guy Put It On Too Tight?

1997 Escort, 62000 Miles, 2.0 Sohc. Car Was Running Great Despite The Need For A Head Gasket. Now, After The Repair, (including Timing...

I Recently Had A New Motor Put In My 95' Aspire. I Have Now Been Told (6 Months Later) That The Motor Mounts Are Going. Where Are The Motor...

When Turning The Ignition, Starter Continues To Make Clicking Sound. Is This For Sure The Starter And Needs To Be Replaced? A Rough Look...

What Is Flywheel Diminsion From Clutch Surface To Pressure Plate Mtg Surface. Had Flywheel Refaced And Not Sure Both Surfaces Were Faced The...

My Starter Spins But It Sounds Like It Is Not Engaging So I Put A New One On It And It Did The Same Thing So I Had A Socalled Mecanic Give...