FLYWHEEL

  • Tiny
  • Myoff Ish
  • 1964 FORD RANCHERO
  • 2WD
  • MANUAL
  • 200,000 MILES

What is flywheel diminsion from clutch surface to pressure plate mtg surface. Had flywheel refaced and not sure both surfaces were faced the same. 1964 ford ranchero, 4cyl. New pressure plate, clutch & brg replaced. Clutch would not release.

Do you
have the same problem?
Yes
No
Wednesday, December 29th, 2010 AT 6:24 AM

1 Reply

  • Tiny
  • Hmac300
  • EXPERT
  • 45,641 POSTS

Usually the refacing only taeks off a few thousandths of an inch. If it's not releasing you may have put teh disc in backwards as some will aloow that to happen. Make sure you have about 1/8" clearance at the release arm as well as making sure your release arm isn't bent.

Was this
answer
helpful?
Yes
No
Thursday, April 7th, 2011 AT 8:40 PM

Please login or register to post a reply.

Other Flywheel Replace/Remove Questions