FORD CRANKSHAFT

So The Truck Has Been Blowing Smoke Out, A Lot Lately. As Soon As I Tried To Start To The Truck It Clicks, Doesn't Turn Over. Tried...

Check Fuel Pump, Selinoid, All Fuses, Battery, Starter.

Were Is It Location At Cam/crank Sensors On A 2000 Ford Contour. So Which One Should I Change Because I Am Not Get No Fire To The Plugs.

No Current From Pcm To Crankshaft Sensor Connector

Truck Started Cranking Longer To Start, Then Just Cranked. Fuses Are Good, Put In New Fuel Pump, Fuel Drive Module, New Throttle Body...

In Replacing Them Both Is There A Certain Way The Replacement Is To Be Done Besides Unplugging The Negative Terminal Of Battery? Also Does...

Does A Crank Shaft Sensor Have Anything To Do With My Van Turning Over But Not Starting?

I Can't Find It If There's A Picture It Would Be Better. I Have A Book But It's Not Helping Much. Thank You Very Much.

Can You Change Crank Bearings Without Pulling The Motor. It Looks Like You Can Get The Pan Off In Yhe Car But Can You Slide The Bearings...

Hey I Have To Do The Crank Bearings On My Truck And Was Wondering What Is The Easyest Way To Do It