FORD CAMSHAFT

I Have Found Both The Blend Door Actuators For The Drivers Side And The Passenger Side. I Have Also Found The Actuator For The...

I Have Replaced The Head Gasket And Now Need To Re-install The Cams. My Exhaust Cam Has A Variable Timing Sprocket That Need To Be Set....

Steering Problem 1989 Ford F250 V8 Four Wheel Drive Automatic Can You Tell Me How To Replace The Actuator Rod For The Ignition On A...

I Have A 1999 Mountaineer With 100k On It. There Should Be A 5 Volt Ref At Thte Gray/red Wire At The Cmp Sensor Which Comes Out Of Pin 85...

I Need To Know For The Truck Listed Above Xl Model Super Crew, Where The Camshaft Position Sensor B Location Is On The Driver Side Is. I...

I Know I Have At Least One Actuator Which Has Gone Bad Due To The Clicking Noise Behind Dash. I’m Just Not Sure Which Actuator I Need To...

I Have A 1998 Ford Explore V-6 65,000 Miles When It Is Cold The Vaules Make A Loud Noise Upon Starting Up Maybe Last About Afew Seconds...

If The Oil Pick Up Tube Did Not Get Sealed Good Would It Make The Lifters On One Side Of The Engine Clatter

I Am Getting Code P0345 And P0349. The Code Indicates Camshaft Position Sensor “a” Circuit (bank 2). I Believe There Are 4 Of Them, I&#...

Seems Like The Pcm Conrtol Relay Is Bad.(The One Under The Air Intake Part Of The Cruise Control) Check Engine Light Comes On After The...