CHRYSLER PT CRUISER

The Car Is Giving A P0340 Code. If It Is Cleared It Comes Right Back On. The Thing Is The Car Starts, Runs, And Drives Great. No Stalling...

We Replaced The Engine With A Used Engine That Has 84,000 Miles On It. The Transmission Worked Fine Before Replacement, But Now It Will...

What Is The Best Way To Replace The Ignition Switch Connector? Do I Need To Solder It Or Clamp It? I Know There Is A Bad Connection There...

So, My Car Only Goes To Limp Mode After Going In Reverse To Back Up Then After I Shift Back To Drive It Will Go Into Limp Mode Almost Every...

The Car Stalled While I Was Driving Home From Work And Would Not Restart. The Battery Is Still Strong. Did The Key Test And Where You Turn...

I Just Had My Head Gasket And Timing Chain Replaced Because It Was Overheating. Now About A Month Later It Is Overheating Again. I Have...

Do I Have To Use Mopar Atf+4 For The Transmission After Fluid And Filter Replacement? Or I Can Use Any Other Atf+4 Brand As Castrol Transmax...

No Compression In One And Three Cylinders. Will Not Start. Replaced Camshaft Sensor, Cam Sender Plugs And Wires.

Had An Upstream O2 Sensor Code, It Was Running Rough Until It Was Warm. Replaced O2 Sensor Now Idle Is High.

Cooling Fan Quit. Car Over Heated. Replaced Fan. Temperature Is Normal Now, But Now No Heat. Replaced Thermostat, Still No Heat. Also, A/...