CHEVROLET DRIVETRAIN

After Driving At 70 For 5 Miles Transmission Shift 1-2 Hard Like A Race Car. Tps?

My Rotors Need To Be Replaced And I Have To Take Apart The Front Hub To Do This. How Would I Go By Removing The Front Rotor And Do I...

Hi, Everybody. Today Crawled Under The Car And Found That The Transmission Box Is A One-touch Thing And She Was In Insulation. And It's...

I Have A Brand New Clutch And A Band New Slave Cylinder. Master Cylinder Worked Fine Before Changing Clutch. Line Was Removed And Is Not...

I Have The Car Listed Above That Ran Fine. The Esc Light Was On. But Ran Fine, All Of A Sudden It Starts To Run Very Badly, Bogged Down...

In A 2000 Chevy 2500 Pickup Duramax 6.5 With A Manual Tranny And Manual Transfer Case Can Gl5 Be Used In The Transfer Case Instead Of Atf. ...

My Clutch Pedal Goes Down To The Floor And Gets Stuck, And I Can't Shift Into Any Gear. I Replaced The Clutch And The Slave Cylinder Last...

I Would Like To Know How To Replace If Can You Send Me The Steps How To Replace It

Need The Size Of The Bolt In The Middle To Remove The Old One Got All Others Done?Thought Might Be 36mm But That's Way Too Big.

2001 S-10. All Factory, No Updgrades Or Additions. U-joints And Carrier Bearing Were Replaced Last Week. Brakes Are Good, Tires Are New...