BUICK

I Need Torquing Specs For The Front Wheel Bearing Bolts.

I Am Replacing The Rear Struts. I Need Factory Info On How To Replace It And What Torquing Specs I Need To Tighten The Bolts.

Replaced Ac/heater Blower Motor, Found A Rat's Nest, Vacuum Out In Area Above Motor. Now It's Not Cooling On Driver Side, Air...

I'm Starting To Feel A Vibration In My Gas Pedal During Acceleration. What Can Cause This?

Replaced Cam And Crank Position Sensors And Icm. After Replacing Each Part, The Car Started Briefly And Then Went Back To Not Starting....

Ignition Cylinder Will Not Go To Off Position Only Goes Forward And It Doesn’t Need A Key In It.

Driving At Night Head Lights Went Out, Had To Pull Forward And Constantly Hold Lever Switch Towards Me To Get Bright Lights To Come On...

I Just Had My A/c Compressor Replaced And Now When I Am Idle, I Hear And Feel A Vibration Coming From Compressor. When I Start To Drive It...

My Car Cuts Off At Idle Once I Drive For 25 Minutes Or So. It Starts Back Up No Problem But Once I Put It In Any Gear Except Neutral It...

Jumped Relay #57 And Motor Turned Over And Started For Only A Few Seconds.