Four wheel drive will not engage

Fuel, temp gage, battery, tach, 4x4 don't work. All of these quit working at the same time. I have changed all gages, checked all the grounds in the engine compartment, changed the GEM. I looked for the grounds under the dash but can't find them. I don't know where to go from here. The 4x4 light on the dash won't light up, and I changed the motor on the transfer case last year. I also checked the fuses. Thanks for your response.

Thanks, It worked well this morning in the snow and ice. There was no clicking noises that I usually hear when I engage it either. Thanks again. Richard

Wiggle the harness were it comes through the fire wall and check the fuse.

Thank you, Could you tell where to find the body control module?

Not sure if they had one in 93

When I push 4wd button on dash nothing happens fuse under hood and fuse under dash good there is power at the switch(pushbutton) where do I go from here? Thank you in advance SteveO

Ok I know what you are going through I had the same problem with my 1993. Oen the compartment that holds your jack it sould be in the back on the driver side. Tack the jack out and all the hard wear to it so you can get a good view of the inside. If you look in the opening towards the front (useing a flash light) you will see a little black computer. With the truck running as you looking in the opening on that computer there should be a little red light lit if it is not lit then you need to go to a junk yeard and get a new one coz that means it is no good. It only tacks about 30 min. To tack it out and put the new one in. If you have any problems just email me asap and I will give you my cell number and talk you through it ok.
Eric
p.S. My email address is eckerson17Yahoo. Com

Drove my son to school came home shut off truck waited 1min went to re start got it started checked for codes and got code po300 misfire detected but no check engine light came on?

I have a 94 f150 4.9 4speed od and was having electrical problems with it and took apart the conection block on the fire wall in witch ford are notorius for having corrosion problems there cleaned and put elect grease on the female side of the block and never had a problem again. Also make sure you have power (12 volts) at both sides of the fuse(if it lights a test light the fuse is good don't just look at the fuse you might not see the break) good luck

Sorry for the screw up trying to fix a broublem with my chevy and was on the wrong page

Electrical problem
1993 Ford Explorer Four Wheel Drive Automatic

I am looking into buying a 4x4 Ford Explorer. When I went to try the 4x4 I pushed the button and all it does is clicks in the rear where the windshield wiper fluid is like its trying to work but wont light up or engage. I checked all fuses and they all seem fine. What is the problem, Is this an easy repair and how much will it cost to fix it?

"Easy Repair" is in the eyes of the beholder. Most likely cause is the 4WD control module on the transmission. It's coslty, but definitely a DIY. You'll spend about an hour under the truck if you've never done one before.

How much is costly and what exactly do I need to buy?

Probably close to $200. And, you'll prob have to go to the Ford dealership to get it. IF, and I mean IF you get one from a junkyard, make sure its the exact same year, and model. They changed this module almost every year because of upgrades.
Before you make the purchase, go to a parts store that does free computer scans. If that module is bad, the code is stored in the computer. The exact code wont come to mind right now, but I know its in the P1800 range.

Drive Train Axles Bearings problem
1993 Ford Explorer 6 cyl Four Wheel Drive Automatic 160k miles

My 1993 explorer 4WD will not engage.
Just happened with no suspicious action on my part.
I push the buttons on the dash either one the low range button or the four wheel drive, the indicator light do not illuminate and the wheels are not in 4WD.
Any suggestions?

4 wheel drive won, t engage