CRANKSHAFT

My Jimmy Has A Very Rough Idle And Is Hard Starting, Rich Exhaust And And After Running For A While The Catiltic Converter Runs Very Hot To...

How Much Labor Time Is Involved In Replacing The Rear Main?

My Truck With 318/ 5.2 Would Stall Out At Times And Within A Few Seconds I Could Restart It. Then It Started To Cough A Little On My Way...

Need To Replace The Engine In A Mazda6 And Found One From Same Make/model/year In Salvage Yard (card Totaled With Rear End Damage Only So...

The Crankshaft Position Sensor Went Bad On My 88 Buick Century With A 3.8 Engine. I Replaced The Sensor And The Car Started Up And Ran Fine...

I Have 97 Mustang Gt Stock Only Mod Bbk Hpipe No Cats. Can Not Seem To Get It To Run Right. I Have Replaced Plugs, Wires, Rear O2 Sensors...

After Replacing The Timing Belt, And Assuming The Crankshaft Position Sensor Was Not Disturbed, Is It Necessary To Perform The "ckp...

Soooooooo. I Kinda Forgot To Change And Check My Oil All Year. Im Sure Yal Know Where This Is Going. Im Driving Along And Outta No Where I...

I'm Getting Two 5 Volt References Of It No 12 12 Volt. I Replaced Because It Started Running Really Bad. Parked In Drive Way Then...

Had At Shop They Changed Plug And Wires Cap, Rotor Button, Camshaft Sensor, Crank Sensor, Throttle Postion Sensor And It Still Reads Miss...