CAMSHAFT CAMSHAFT SENSOR

When I Start My Car It Runs Fine, But When It Warms Up And I Go On The Freeway At 55 It Starts To Sputter And I Have To Rev Up The Engine...

Ive Got A 99 Explorer With 5.0 And Keeps Setting Cam Code 340. I Got This From Another Shop, They Already Replaced The Cam Sensor And Oil...

We Replaced The Cam Sensor And Checked For Spark. We Have Spark And The Car Will Run When The Air Horn Is Sprayed With Starting Fluid. There...

Vehicle Had No Loss Of Power, No Stalling Problems, No "hard Starting" Issues, Started One Morning Was Turned Off For A Minute Or...

Well. After 3 Cam Sensors (inside Dist), 3rd Being Dealer, Going Thru All The Wiring, Replacing The Crank Sensor, Re-indexing The...

Engine Mechanical Problem 1997 Ford Explorer V8 All Wheel Drive Automatic To Set Cam Sensor It Says Go To Notch In Pulley. Do I Go To...

We Replaced The Cam Sensor And The Code Kept Coming Up. We Took A Continuity Test On The Leads And Found Both Leads Were Hot. Is That...

My Van Want Turn Over To Start. I Put New Coil Pack New Cam Shaft Position Sensor New Crank Shaft Sensor And New Fuel Pump And None Of That...

Other Category Problem 2000 Ford Taurus 6 Cyl Wheel Drive Type Unknown Automatic 116332 Miles Hello, I Went To Get My...

Dear Bob/ken I Have Vehiacal Cant Start, I Check Theirs No Spark, I Check Electrical Its Ok, But I Dnt Knw How To Test Cam, Crank Shaft...