SUBARU COMPUTER

Found 25 results

Select a filter to limit the results

Clear Codes Limp Mode - Reduced Power Location Monitor Not Resetting No Communication Program Read Codes Replace/Remove

2003 Subaru Baja Reset Check Engine Light

2003 Subaru Baja How Do I Reset The Check Engine Light On This Car? It Came On Due To An O2 Sensor (rear One 2nd In Line) Which A...

Asked by Barton ·

1 ANSWER

2003

Engine Computer

Engine Computer

The automotive engine computer, also known as the ECU, PCM or ECM (Engine control unit, Powertrain control module, Engine control module), is central to a vehicle’s ...

2003 Subaru Baja OBD Drive Cycle

Computer Problem 2003 Subaru Baja 4 Cyl All Wheel Drive Manual 30k Miles The Check Engine Light Is On After Being Reset More Times...

Asked by naalii ·

2 ANSWERS

2003

LIMP Mode/ECU

I Had The Transmission Rebuilt About Two Years Ago. I Got A Flat Tire Put The Spare On And After That It Seems The Transmission Was Messing...

Asked by Dutchgirl ·

1 ANSWER

2000

Evap Monitor Reset?

How Many Miles Due I Have To Drive To Reset Evap Monitor On My 1999 Subaru Legacy Outback?

Asked by kimc1975 ·

1 ANSWER

1999

OBDii Non Communication

I Have Done A Number Of Repairs On My Vehicle, Including Replacing The Catalytic Converter And Both My O2 Sensors. However, I Cannot Pass...

Asked by rlbrubak ·

1 ANSWER

3 IMAGES

2002

2010 Subaru Legacy Computer Configuration

Can The Computer Be Configured To Automatically Lock The Door When The Car Reaches 6 Mph? Also Would Like Th Key Fob To Open And Close The...

Asked by brendabe71 ·

1 ANSWER

2010

Engine Computer Symptoms

Engine Computer Symptoms

The Engine Control Module (ECM) is a vital component in modern vehicles, responsible for managing engine performance, fuel economy, and emissions. When the Engine Computer...

2004 Subaru Outback How To Fix Diagnostic Code...

My Sabaru Recieved Three Dianostic Code Readings. Can You Tell Me What Speciifically Needs To Be Fixed? 1. Po420 (orange Light) - Catalyst...

Asked by bodiepostel ·

1 ANSWER

2004

Cannot Connect The Scan To My Car

I Tried To Connect To Read My Check Engine Code, But It Does Not Want To Connect. I Tried With Two Scanners And Still Does Not Want To...

Asked by Jake09 ·

1 ANSWER

2 IMAGES

2007

OBD Not Communicating?

We Moved And Needed To Get An Admission Test. The Emission Tester Couldn't Connect And Mentioned That It Could Be A Blown Fuse. No Other...

Asked by Jpytell ·

1 ANSWER

2 IMAGES

2016

Getting Flash Code

I Have A 91 Subaru Legacy L+ With A 2.2 L Mfi Engine, With Distributorless Ignition. It Runs Fine At High Rpms, But Idles Rough. The...

Asked by briancarpenter ·

1 ANSWER

1991

Ask a new Subaru question

Ask a Car Question. It's Free!

© 1999 - 2025 2CarPros, Inc.