SPONSORED LINKS

1996 JEEP SENSOR PROBLEM

  • Tiny
  • mrmechanic
  • 1996 Jeep Cherokee

I am the (unproud) owner of a 1996 Jeep Grand Cherokee Laredo. I have replaced both the crankshaft and camshaft position sensor twice. After about a week, I am getting the same error codes again! Any suggestions?

SPONSORED LINKS
Do you
have the same problem?
Yes
No
Wednesday, May 17th, 2006 AT 11:58 PM

2 Replies

  • Tiny
  • vandragon
  • Member

Yes, get rid of it like my soninlaw did his before it cost you an arm and a leg.

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, May 18th, 2006 AT 9:44 AM
  • Tiny
  • mrmechanic
  • Member

Did he trade it in or was he able to sell it? I really hate passing this serious of a problem on to someone else.

Was this
answer
helpful?
Yes
No
Thursday, May 18th, 2006 AT 2:56 PM

Please login or register to post a reply.

Similar Questions

2000 Jeep Cherokee Fuse Blowing

I Have A No Start Situation Thatstarted With The Engine Missfiring And It's Blowing The #18 Fuse I've Replaced Cpr Sensor Re Index The Cam ...
Asked by bukowy88 ·
3 ANSWERS

1995 Jeep Cherokee Whats Wrong With My Car??

When Its Cold My Car Starts Fine, When I Drive It For A Bit It Goes Great, But When It Goes Over 110 Degrees It Will Stall And Not Start ...
Asked by penrithguy83 ·
1 ANSWER

Shuts Down When It Wants

I Have A 1998 Jeep Grand Cherokee That Shuts Down When It Want And Then I Can Start It Right Back Up I Have Changed The Cam Sensor And The ...
Asked by kwjohn ·
3 ANSWERS

Please I Need Help On Jeep Grand Cherokee

I Have A 1999 Jeep Grand Cherokee 160000 Miles On It 6 Vyl. 4x4 It Stalls When I Slow Up Not All The Time Though Some Times It Runs Like A ...
Asked by joanneniemiec ·
1 ANSWER