cam position sensor Jeep

1996 JEEP CHEROKEE
100,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
CHARLESDYER
  • MEMBER
  • 1 POST
How to change cam position sensor jeep 1996 cherokee 6 cylinder
Dec 22, 2010 at 1:02 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
REMOVAL

1. Disconnect negative battery cable.
2. Remove distributor cap.
3. Disconnect electrical connector at camshaft position sensor.

NOTE: DO NOT pull on sensor electrical lead.

4. Remove distributor rotor.
5. Lift camshaft position sensor off distributor housing.

INSTALLATION

1. Install camshaft position sensor on distributor housing.
2. Install distributor rotor.
3. Connect electrical connector at camshaft position sensor.
4. Install distributor cap.
5. Connect negative battery cable.
Sep 29, 2020 at 11:11 AM