Axle not spinning/Not stalling

EVO

MEMBER
HONDA

I'm currently done with replacing my tranny for my 93 hatchback si. I had put everything back into place. I started the car fine, but my passenger side axle wasn't spinning on it's own. What do you think is the problem? I changed the speed thing, but it's still the same. Another question is. When I put it into first gear and let go of the clutch nothing happened. It didn't stall? Why didn't it stall?

Wednesday, January 31st, 2007 AT 7:46 AM

1 Reply

KNIGHTRIDERKITT2000

MEMBER
93 POSTS

No offense intended, but are you sure you installed the tranny right, second the clutch did not engage when you put it in gear, I would check to make sure the tranny is installed and hooked up right, do you have a repair manual that might help you with the installation.

Also did you replace your tranny with new or used, if you replaced it with a used one that one might be bad

Was this

answer

helpful?

Yes

Wednesday, January 31st, 2007 AT 8:01 AM