I just put front pads on 1 year ago. Inboard pad on right side looks new. Outboard pad very worn. What would cause this?
Do you
have the same problem?
Yes
No
Friday, March 27th, 2009 AT 9:38 PM
3 Replies
OBXAUTOMEDIC
MECHANIC
3,711 POSTS
Hello,
Most likely it is the caliper housing bolts are stuck holding to outer pad against the rotor.
.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Friday, March 27th, 2009 AT 9:48 PM
1CM2
MEMBER
2 POSTS
Thanks, I didn't turn the rotors and then noticed the pedal pulsating at high speeds. Mighta had somethin to do with it. Took em off this time, carried them 2 miles to get turned; should be good this time.
Was this
answer
helpful?
Yes
No
Saturday, March 28th, 2009 AT 6:25 PM
1CM2
MEMBER
2 POSTS
I ended up putting 25 year-old High temp disc brake bearing grease on the caliper pins. I remember getting the can and it's been laying around here since. Hope that'll work.
When I got it apart, I saw the pads were evenly worn. At first glance through the caliper, that's what I thought I saw.