2000 Ford Expedition Heater blower motor

Tiny
BUTCHLOVETT
  • MEMBER
  • 2000 FORD EXPEDITION
2000 Ford Expedition

How do you install a heater blower motor
Do you
have the same problem?
Yes
No
Wednesday, January 14th, 2009 AT 7:23 PM

1 Reply

Tiny
JACOBANDNICKOLAS
  • EXPERT
It's under the dash and will require somework to get to it. On 5.4L and 6.8L engines, perform the following:
DISCONNECT THE BATTERY AND ALLOW THE CAR TO SIT FOR APROX 10 MINUTES BEFORE STARTING.

Disconnect the speed control servo connector.
Remove the bolts and remove the speed control servo.
Disconnect the connector.
Remove the blower motor ventilation tube. WARNING
Carefully remove the blower motor so as not to damage the wheel.
Remove the screws and remove the blower motor. WARNING:
If the wheel is to be reused, clean the corrosion from the shaft end prior to removing the wheel otherwise it may break when removed.
Remove the wheel from the blower motor.
Remove the push clip.
Remove the wheel from the blower motor.
Installation is the reverse of the removal procedure. Tighten the blower motor screws.
Remove the RH lower instrument panel insulator.

For Expedition models:
Remove the RH scuff plate.
Remove the RH lower A-pillar trim panel.
Position the carpet aside.
Remove the blower motor, as follows:
Disconnect the electrical connector and position the wire harness aside.
Remove the screws, then remove the blower motor.
Detach the electrical connector (1), remove the screws (2) and remove the blower motor (3)
Installation is the reverse of the removal procedure


http://www.2carpros.com/forum/automotive_pictures/249084_0900c152801e9de3_1.jpg



I hope this helps.
Joe
Positive feedback is appreciated.
Was this
answer
helpful?
Yes
No
Friday, January 16th, 2009 AT 12:27 PM

Please login or register to post a reply.

Recommended Guides