SPONSORED LINKS

Toggle switch

Tiny
DTAKAH
  • MEMBER
  • CHEVROLET
We would like to aliminate are key switch and just use a toggle switch on are 1950 chevy car, how would we wire this, I did it how I thought it would go, and everytime I hit the start button the neg on the battery sparks. It doesnt start unless I put gas in it, then it stops when it runs out from the carberator, thanks deb
SPONSORED LINKS
Monday, August 6th, 2007 AT 7:46 AM

1 Reply

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
The way I do it when I was 14-I go underneath find the main power input feed-go disconnect the battery-go back and cut the feed wire-find a house switch put the feed on one side, find the wire that activates the starter cut it out connect it to the push buttton and the other end ( jumper wire ) to the feed. The rest of the wires cut it out and put it on the other side of the house switch and your DONE

Good Luck
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, August 6th, 2007 AT 6:30 PM

Please login or register to post a reply.

Related Engine Not Running Content

How to fix an engine that wont start
VIDEO
How to fix an engine that wont start
Instructional repair video
Engine Not Starting - Top 3 Easy Steps
GUIDE
Engine Not Starting - Top 3 Easy Steps
Over the past 20 years on 2CarPros we have identified the top three problems that are easily fixed. This can save you a trip to the repair garage or calling a tow truck and...
VIEW MORE

Sponsored links